Bosch Security System Owner's Manual page 25

CHG SKEDS ?
Description
A Sked is a function programmed to be performed automatically at a scheduled time by your
security system. You can change the scheduled time for some functions, disable the Sked and thus
prevent it from automatically happening or restart a previously disabled Sked. Contact your
security representative to determine what Skeds may be programmed for your system.
Using Chg Skeds:
To change a Sked's time, enable a Sked, or disable a Sked, follow the procedure below to first select
the Sked from a list of Skeds programmed for your system.
1. Ensure your command center is at idle text.
2. Press the [COMMAND] bar. The display shows SYSTEM COMMAND.
3. Press the [5] key, then press the [2] key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the [MENU] key to enter the Command Menu, then press [NEXT] repeatedly until you
reach the CHG SKEDS ? prompt. Press [ENT].
4. The number of the first Sked programmed into your system is displayed, plus either its
time or an indication that it is disabled. Press [NEXT] to scroll through the list of Sked
numbers to find the one you wish to change.
• When an X appears in the Sked display, it is an indication that "Except on Holidays"
is enabled, S ## X ##:##AM.
• When an * appears in the Sked display, it is an indication that the Sked has or will
happen today, S ## * X ##:##AM.
• To change the state of the displayed Sked from enabled or disabled:
1 . With the selected Sked displayed, press [ENT].
2. If the Sked is currently enabled, DISABLE ? is displayed. Press [ENT]. The Sked
displays showing it is disabled.
3. If the Sked is currently disabled, ENABLE ? is displayed. Press [ENT]. The display
shows XOH ON ? You can toggle between this display and XOH OFF ? by pressing
[NEXT]. To enable the Sked on holidays, press [ENT] with XOH OFF ? displayed. To
disable the Sked on holidays, press [ENT] with XOH ON ? displayed.
• Enter the desired time and press [ENT].
• AM ? displays. To choose AM, press [ENT]. To choose PM, press [NEXT] to
display PM ?, then press [ENT].
• The display shows the Sked with its new time.
4. Press [ESC] to return to idle text.
52