Bosch Security System User Manual page 56

Part II: System Commands
WALK TEST ? (COMMAND + 4 + 4)
Using Walk Test:
1. Ensure your
command center
shows idle disarmed
text.
2. Press the COMMAND
key.
The display shows
*System Command*.
3. Press the 4 key,
followed by the 4 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the WALK TEST ?> prompt. Press the
WALK TEST ?> soft key.
4. The burglary bell sounds for 2 seconds.
Security System User's Guide
Note:
+
5.
When the display
shows ### points
remain to be tested you
can begin. (### is the
number of points)
If you know the point number, you
can enter it by pressing its number
key and then the ENTER key.
The display will change to show the point that
was entered. If the point is invalid the message
Invalid Point or This is not a valid walk point
appears.
Test each point by first opening and then closing the
door or window.
Check the display after testing each point. For
interior points, walking past the device once is
sufficient. If any point does not test correctly,
contact your security company for service.
During the Walk Test
you may want to see the
points that remain
untested.
4998122475C