Program Mode - Metrologic ScanPal 2 User Manual

Program Mode

This is the default operating mode when the ScanPall2 is powered up. It depends
on the user program loaded into the Program module.
The application interpreter and its inventory application, loaded by default,
displays the following main menu:
The counter, located in the bottom right-hand corner of the screen, displays the
number of records collected.
1. Collect data
Data collection starts after confirmation of the Collect data operation, using the
, key.
A new screen displays the following two prompts:
Item:
Qty: 1
Item (Article) prompt expects an item code, read by the scanner or entered
The
on the keypad and confirmed by the
Qty (Quantity) prompt offers, by default, a quantity of 1, which can be
The
modified by entering on the keypad the new quantity desired. This is confirmed
using the
prompts are displayed again.
ESC
Pressing the
1.Collect data
2.Upload data
3.Utilities
JUN 16, 13:30 00000
key. The data collected are then recorded and the two
key allows a return to the main menu.
(R)
key.