Table of Contents
Advertisement
Basic adjustment settings
Power control
Power control setting allows you to save energy.
Power control for AV source
No Signal off
When set to "Enable", the power will automatically shut
down if no signal inputs for 15 minutes.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "No Signal Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
• When a TV programme finishes, this function may not
operate.
No Operation off
When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "No Operation Off", and
then press ENTER.
4
Press c/d to select "Enable", and then
press ENTER.
•
Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
30
Power control for PC source
Power control setting allows you to save energy.
Power management
When set, the power will automatically shut down.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Power control".
• Power control menu displays.
3
Press a/b to select "Power Management",
and then press ENTER.
4
Press a/b to select "Mode1" or "Mode2",
and then press ENTER.
Selected item
• No power management
Off
• Factory preset value.
• If no signal inputs for 8 minutes, the power
shuts down.
• Even if you start using the PC and the signal
inputs again, the TV stays off.
Mode1
• The TV turns on again by pressing POWER
on the TV or POWER on the remote control
unit. (See page 14.)
• If no signal inputs for 8 seconds, the power
shuts down.
• When you start using the PC and the signal
inputs again, the TV turns on.
Mode2
• The TV turns on again by pressing POWER
on the TV or POWER on the remote control
unit. (See page 14.)
Off
Mode1
Mode2
Description
Advertisement
Table of Contents
