The Oven Door Handle, Top Trim, & Outer Door Glass - Whirlpool ESTATE TES325E W Service Manual

Freestanding self-clean electric range
Hide thumbs Also See for ESTATE TES325E W:
Table of Contents

Advertisement

THE OVEN DOOR HANDLE, TOP TRIM, & OUTER DOOR GLASS
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electrical
shock.
CAUTION: When you work on the electric range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
REMOVING THE OVEN
DOOR HANDLE & TOP TRIM
1.
Turn off the electrical supply to the range.
2.
Open the oven door, remove it (refer to page
1-14 for the procedure), and position it on a
protected floor with the handle and outer door
glass facing up.
3.
Remove the two door mounting screws from
the liner side of the door.
4.
Lift the door liner and remove the two screws
from the old door handle and top trim.
5.
Mount the new handle and top trim to the oven
door.
6.
Reinstall the oven door on the range.
MOUNTING SCREWS
TOP TRIM
HANDLE
HANDLE & TRIM
DOOR LINER
MOUNTING SCREWS
OUTER DOOR
GLASS
SET GLASS
BOTTOM TRIM
Cooking Products Service Manual
Original July, 1996
© 1996 Whirlpool Corporation
REMOVING THE OUTER
DOOR GLASS
1.
Turn off the electrical supply to the range.
2.
Remove the oven door (see page 1-14 for the
procedure), and position it on a protected
floor with the handle and outer door glass
facing up.
3.
Raise the top of the door and remove the two
screws that secure the top of the door trim and
the handle to the door liner, then remove the
handle and top trim.
4.
Slide the outer door glass out of the bottom
trim channel and install the new glass in its
place.
5.
Install the top trim and handle on the oven
door and secure them in place with their two
mounting screws. REASSEMBLY NOTE: The
side trim on Whirlpool oven doors fits under
the top edge of the outer door glass, and the
side trim on Roper models fits over the top
edge of the glass. Make sure that the trim is
seated properly when you tighten the screws.
6.
Reinstall the oven door on the range.
3-25
4321893
Page 3-25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents