Connecting The Range To An Electrical Supply - Whirlpool ESTATE TES325E W Service Manual

1. Turn off the power to the main supply.
2. Remove the terminal block cover screws that
are located on the back of the range, then
lower the cover, unhook the tabs, and pull it
towards you to remove it.
pull down
to remove
2 mounting
tabs, each side
CONNECTING THE RANGE
TO AN ELECTRICAL SUPPLY
WARNING
Electrical Shock Hazard
Electrical ground is required on this range.
Do Not connect to the electrical supply until the
range is permanently grounded.
Disconnect the power to the junction box before
making the electrical connection.
This range must be connected to a grounded,
metallic, permanent wiring system or a ground-
ing connector should be connected to the ground-
ing terminal or wire lead on the range.
Failure to do so could result in death or serious
injury.
terminal
block
cover
3/8" brass
nuts located
inside cover
Cooking Products Service Manual
Original
© 1996 Whirlpool Corporation
NOTE: Depending on your electrical supply, make
the three-wire or four-wire connection by following
the instructions for the "Power Supply Cord Method"
or "Direct Wire Method" on page 1-6.
quadrex
screws
1-5
4321893
July 1996
Page 1-5