Removing The Electronic Oven Control Or Mechanical Oven Thermostat - Whirlpool ESTATE TES325E W Service Manual

REMOVING THE ELECTRONIC OVEN CONTROL
OR MECHANICAL OVEN THERMOSTAT
WARNING
Electrical Shock Hazard
Disconnect from electrical supply before servic-
ing unit.
Failure to do so could result in death or electrical
shock.
CAUTION: When you work on the electric range,
be careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
REMOVING THE ELECTRONIC
OVEN CONTROL
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the electrical supply to the range.
3. Remove the screws from the back panel and
remove the panel.
4. Remove the mounting screws from the old
electronic oven control and remove the con-
trol. Do not disconnect the wires yet.
5. Mount the new electronic oven control to the
console panel.
6. One at a time, disconnect each wire and
connector from the old electronic oven con-
trol, and connect it to the same terminal loca-
tion on the new control.
7. Reassemble the range.
ELECTRONIC OVEN
CONTROL
CONSOLE PANEL
REMOVING THE MECHANICAL
OVEN THERMOSTAT
1. Pull the range away from the wall so that you
can access the back.
2. Turn off the electrical supply to the range.
3. Remove the screws from the back panel and
remove the panel.
4. Pull the knob off the thermostat control shaft.
CONSOLE PANEL
MOUNTING
SCREW (2)
CONTROL KNOB
THERMO-BULB
(ON OVEN LINER)
5. Remove the mounting screws from the ther-
mostat and remove it from the back of the
control panel.
6. Disconnect the two wires from the oven ther-
mostat terminals.
7. From inside the oven, unclip the thermo-bulb
from the liner and push it and the capillary
tube through the hole in the back of the liner.
8. Mount the new thermostat and thermo-bulb to
the range.
9. Reassemble the range.
3-12
WIRES
THERMOSTAT
4 5 0
CAPILLARY
TUBE
HOLE IN
OVEN LINER