Removing The Oven Door Glass - Whirlpool SELF-CLEANING SLIDE-IN GAS RANGES Manual

REMOVING THE OVEN DOOR GLASS

WARNING
Electrical Shock Hazard
Disconnect from electrical and gas supplies
before servicing unit.
Failure to do so could result in death, electri-
cal shock, or explosion.
CAUTION: When you work on the range, be
careful when handling the sheet metal parts.
Sharp edges may be present, and you can cut
yourself if you are not careful.
NOTE: The oven door has three glass panels
(see Figure 4-16). To replace the oven glass
panels inside the door, you must first remove
the door glass. To replace the inner oven glass,
you have to first remove the door glass and the
outer oven glass panels. Refer to the section(s),
as necessary.
Figure 4-16
Door Handle
Assembly
Door Glass
Outer Oven Glass
Inner Oven Glass
4-22
Refer to Figure 4-17 for the following steps.
1. Open the oven door to the first (broil) stop.
2. Grasp the oven door on both sides. Simul-
taneously lift straight up and pull out on the
door approximately 2-inches to release
the hinge brackets from their stop.
3. Close the door completely so it is perpen-
dicular to the floor, then pull the door out of
the oven tracks, and place it on a clean
padded surface.
4. Position the door upside down so that it
rests on the top of the handle assembly,
(see Figure 4-18), and remove the four
screws from the door glass retainer.
DOOR GLASS RETAINER
SCREW SCREW
DOOR
Figure 4-18
OVEN DOOR
DOOR HINGE
Figure 4-17
SCREW SCREW