Table of Contents
Advertisement
REPLACE OIL FILTER
Replace oil filter every 50 hours of use or
annually.
1. Clean dirt and debris from oil filter and
surrounding area.
2. Place mower in the Service Position.
See SERVICE POSITION on page 20.
3. Place a suitable container below engine
oil fill tube and remove cap to allow oil to
drain from tube.
4. Turn oil filter counterclockwise to
remove. See Figure 23.
5. Apply a thin coat of oil onto seal of new
filter.
6. Install new filter and hand tighten
securely.
7. Tip mower back down onto its wheels.
8. Add engine oil. Refer to Engine Manual
for instructions and proper oil type.
9. Install oil fill cap.
10. Remove plastic from fuel cap and
connect spark plug wire to spark plug.
Oil Fill Tube with Cap/Dipstick
Oil Filter
Figure 23
CHECK MUFFLER
Check muffler for debris, cracks, wear, or
other damage every 50 hours of operation.
CAUTION: Replace worn-out
mufflers immediately. Continued
use could result in fire or
explosion.
REPLACE SPARK PLUG
Spark plug should be replaced every 100
hours of operation or annually. See engine
manual for specific information.
NOTE: Loose spark plug wire terminals can
cause sparking. Replace terminal if
damaged.
GB - 22
Advertisement
Table of Contents
