Table of Contents
Advertisement
Support Clamp
Cable
Tie
Recoil Rope Set-Up
Loosen lock nut on inner side of handlebar
bracket until rope guide mounting cap screw
is loose enough to allow lower half of guide to
be rotated away from upper half, opening
rope guide. See Figure 10.
1. Hold OPC lever fully depressed while
slowly pulling recoil rope out past
handlebar. Release OPC lever while
holding recoil rope extended. See
Figure 11.
Handlebar
Cable Tie
Handlebar
Support
Figure 9
Recoil Rope
2. Position recoil rope in upper half of
guide and then rotate lower half back to
close guide, capturing rope. See
Figure 10.
OPC Lever
See
Figure 10
NOTE: Ensure mounting cap screw is
properly seated in lower half of rope guide.
3. Tighten lock nut on inner side of
handlebar bracket to secure rope guide
halves together.
GB - 12
Mounting Cap Screw
Rope
Guide
Opened
Figure 10
Handlebar
Bracket
Recoil
Rope
Figure 11
Rope
Guide
Closed
Advertisement
Table of Contents
