Table of Contents
Advertisement
Frame
Wheel
Inside View
Figure 18
Front Wheel Height Adjustment
See Figure 19
IMPORTANT: Front wheel height must be set
the same as rear wheel height for proper
height of cut.
1. Stop engine, wait for all moving parts to
stop and hot parts to cool.
2. Place unit on a flat, level surface.
3. Disconnect spark plug wire from spark
plug.
4. Raise front of mower to lift front wheels
off the ground. Support front of mower
deck with jackstands, blocking or other
similar, stable support.
The height of the standard, fixed front wheels
Height
is changed by raising or lowering wheels in
of Cut
the four available mounting holes in each
Holes
wheel support. Place wheels in upper holes
for a lower cut and lower holes for higher cut.
NOTE: Height-of-cut holes are spaced
approximately 0.665" (17mm) apart. The
mower is set-up at the factory in the second
Axle
from the lowest position, for a 2.7" (69mm)
Bolt
cut height.
5. Hold axle bolt stationary with wrench
while removing inner nut.
6. Move each front wheel and axle bolt to
desired height-of-cut hole.
7. Hold axle bolt stationary with wrench
while tightening inner nut against
support.
8. Connect spark plug wire to spark plug.
Inner
Nut
Axle
Bolt
Support
GB - 18
Wheel
Outer
Height
of Cut
Figure 19
Nut
Holes
Advertisement
Table of Contents
