JVC GY-HD110 Instructions Manual page 95

TALLY lamp
Blinks when remaining battery power or tape is low. (Only
in Camera mode)
Blinking Pattern
Slow blinking • Remaining battery power is low.
(once per sec.) • Remaining tape time is equivalent to less
than 3 minutes.
Fast blinking • Tape has run out.
(four times per sec.) • Irregularity has occurred in the VTR.
Alarm Sound
When remaining battery power becomes low, a warning
sound is output from the monitoring loudspeaker and the
PHONES jack.
(In Camera mode only)
When an irregularity occurs in the VTR, a warning sound is
also output.
Whether or not alarm sound should be output and the vol-
ume level are selected with the ALARM VR LEVEL item on
the OTHERS [1/2] menu screen.
Depending on the alarm conditions, the warning indicators
on the LCD monitor/viewfinder screen, the TALLY lamp,
and alarm sounds appear as shown in the following table.
Alarm Indications on LCD Monitor/
Viewfinder Screen
VTR alarm indication
(Example)
Display symbols J
Remaining Battery/Tape
TALLY lamp
I
J
I
J
: Blinking once per second.
: Sound interrupted once per second.
Alarm Sound
Dew formation (condensation) or error has oc-
curred in the VTR.
About 3 min. before tape end
(displayed during recording).
Tape end
(displayed during recording).
Remaining battery power is low.
I : Blinking four times per second.
: Continuous sound.
OTHERS
Condition
91