Interrupt Request Table For This Motherboard; Agp Slot; Connectors, Headers; Connectors - JETWAY PM2M User Manual

2-5-3 Interrupt Request Table For This Motherboard

Interrupt request are shared as shown the table below:
Slot 1
Slot 2
Onboard USB 1
Onboard USB 2
AC97/MC97
IMPORTANT! If using PCI cards on shared slots, make sure that the drivers support

2-5-4 AGP Slot

This motherboard provides an AGP Slot, support the 2X/4X AGP VGA card.

2-6 Connectors, Headers

2-6-1 Connectors

(1) Power Connector (20-pin block) : ATXPWR
ATX Power Supply connector. This is a new defined 20-pins connector that usually
comes with ATX case. The ATX Power Supply allows to use soft power on momentary
switch that connect from the front panel switch to 2-pins Power On jumper pole on the
motherboard. When the power switch on the back of the ATX power supply turned on,
the full power will not come into the system board until the front panel switch is
momentarily pressed. Press this switch again will turn off the power to the system
board.
INT A INT B
√
√
"Shared IRQ" or that the cards don't need IRQ assignments. Conflicts will
arise between the two PCI groups that will make the system unstable or
cards inoperable.
INT C INT D INT E
√
2x notch
11
INT F INT G
√
4x notch
AG P SLO T
INT H
√