Onboard Super Io Function - JETWAY 865GDM User Manual

Select Enabled if your system contains a Universal Serial Bus (USB) controller and you have
a USB keyboard. The settings are: Enabled, Disabled.
On-Chip Serial ATA
The settings are: Disabled, Auto, Combined Mode, Enhanced Mode, SATA Only.
Default setting is Auto. Due to the Intel ICH5 Specification limited only provided two
controllers. When plug the Serial ATA hard drive in SATA1 or SATA2 only can support either
IDE1 or IDE2 can works in Windows 9X/ME/2000. But in the Windows XP the OS can
support 6 IDE devices both IDE1, IDE2 and SATA1/SATA2 can works.

3-7-3 Onboard Super IO Function

CMOS Setup Utility – Copyright(C) 1984-2003 Award Software
Onboard FDD Controller
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
IR2 Duplex Mode
Onboard Parallel Port
Parallel Mode
ECP Mode Use DMA
↑ ↓ → ←
Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F5:Previous Values
Onboard FDD Controller
Select Enabled if your system has a floppy disk controller (FDD) installed on the system board
and you wish to use it. If you install add-on FDC or the system has no floppy drive, select
Disabled in this field. The settings are: Enabled and Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and the second serial ports. The
settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled, Auto.
UART Mode Select
This item allows you to determine which InfraRed(IR) function of the onboard I/O chip, this
functions uses.
Onboard Parallel Port
There is a built-in parallel port on the on-board Super I/O chipset that Provides Standard, ECP,
and EPP features. It has the following option:
Disabled
(3BCH/IRQ7)/
(278H/IRQ5)/
(378H/IRQ7)
Parallel Port Mode
Onboard Super IO Function
Enabled
3F8/IRQ4
Disabled
Normal
Half
378/IRQ7
SPP
3
F6:Optimized Defaults
Line Printer port 0
Line Printer port 2
Line Printer port 1
Menu Level >>
F7:Standard Defaults
27
Item Help
F1:General Help