Honeywell S7999D SOLA User Manual page 42

Table 59. Status Tables.
Name
CH
DHW
Burner Control
Demand and Modulation
Inlet High Limit
Fan
Pump
Flame Detection
Statistics
Stack Limit
Lead Lag Slave
Lead Lag Master
Parameters
A complete list of configurable parameters is shown in Table
60.
Table 60. Configurable Parameters.
Parameter Comment
Boiler Name Name to identify boiler (up to 20
characters)
Installation Notes regarding installation (up
to 20 characters)
Installer Change installer password
password setting
OEM Change OEM password setting
password
Factory Data OEM name to associate with
boiler (up to 20 characters)
65-0315—02
Table # Page #
44 30
45 31
46 32
47 33
48 33
49 33
50 34
51 34
52 34
53 35
54 35
55 35
Table Page
# #
5 14
42
Table 60. Configurable Parameters. (Continued)
Parameter Comment
CH enable Disable or Enable Central
Heating Loop
CH demand Sensor for Central Heat
switch demand:
Sensor only
Sensor & STAT terminal
Sensor & Remote Stat
LCI & Sensor
CH Outdoor Enabled
reset Disabled
CH has Yes, No, Cancel
priority over
Lead Lag
CH Setpoint Local
source S2 (J8-6) 4-20mA
CH Setpoint Setpoint for normal Central
Heat modulation:
-40 °F to 266 °F
(-40 °C to 130 °C)
CH time of Setpoint when Time Of Day
day setpoint switch is on. -40 °F to 266 °F
(-40 °C to 130 °C)
CH off Differential above setpoint
hysteresis when boiler is turned off. -40 °F
to 266 °F (-40 °C to 130 °C)
CH on Differential from setpoint when
hysteresis boiler is turned on.-40 °F to 266
°F (-40 °C to 130 °C)
4 mA water -40 °F to 266 °F
temperature (-40 °C to 130 °C)
20 mA water -40 °F to 266 °F
temperature (-40 °C to 130 °C)
Modulation Outlet sensor, Inlet sensor, S5
sensor (J8-11)
Modulation Local
Rate Sensor
CH P-gain Time between hysteresis step
changes: 0-400
CH I-gain Time between hysteresis step
changes: 0-400
CH D-gain Time between hysteresis step
changes: 0-400
Hysteresis Time between hysteresis step
step time changes: 0-600 seconds
(0=Disable hysteresis stepping)
Table Page
# #
7 15