Table of Contents
Advertisement
1. Trim tab
2. Bolt
3. Cap
Bolt tightening torque:
42.0 Nm (31 ft-lb) (4.2 kgf-m)
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
A
B
ZMU01863
Basic components
clamp bracket.
ECM00660
CAUTION:
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
an additional support device to secure it
in the tilt position.
EMU26382
Top cowling lock lever (pull up type)
To remove the engine top cowling, pull up
the lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling by moving the lever(s) down-
ward.
1
1. Top cowling lock lever(s)
ZMU01864
ZMU04933
23
Advertisement
Table of Contents
