Operation
to allow operation in shallow water.
EWM00660
WARNING
Place the gear shift in neutral before
G
setting up for shallow water cruising.
Return the outboard motor to its normal
G
position as soon as the boat is back in
deeper water.
ECM00260
CAUTION:
Do not tilt the outboard motor up so that
the cooling water inlet on the lower unit is
above the surface of the water when set-
ting up for and cruising in shallow water.
Otherwise severe damage from overheat-
ing can result.
EMU32920
Procedure for power trim and tilt
1.
Place the remote control lever in neutral.
2.
Slightly tilt the outboard motor up to the
58
N
ZMU04588
desired position using the power trim
and tilt switch.
UP
UP
DN
UP
UP
3.
To return the outboard motor to the nor-
mal running position, press the power
trim and tilt switch and slowly tilt the out-
board motor down.
EMU28193
Cruising in other conditions
Cruising in salt water
After operating in salt water, flush the cooling
water passages with fresh water to prevent
ZMU01935
ZMU04602
ZMU01954