Basic components
UP
DN
NOTE:
For instructions on using the power trim and
tilt switch, see page 55.
EMU26162
Power trim and tilt switches (twin
binnacle type)
The power trim and tilt system adjusts the
outboard motor angle in relation to the tran-
som. Pushing the switch "
outboard motor up, and then tilts it up. Press-
ing the switch "
" (down) tilts the outboard
motor down and trims it down. When the
switch is released, the outboard motor will
stop in its current position.
1
DN
UP
1. Power trim and tilt switch
NOTE:
On the dual engine control, the switch on
G
the remote control grip controls both out-
board motors at the same time.
22
G
EMU26243
Trim tab with anode
The trim tab should be adjusted so that the
steering control can be turned to either the
right or left by applying the same amount of
force.
EWM00840
ZMU01862
An improperly adjusted trim tab could
cause difficult steering. Always test run
after the trim tab has been installed or re-
placed to be sure steering is correct. Be
sure you have tightened the bolt after ad-
justing the trim tab.
If the boat tends to veer to the left (port side),
turn the trim tab rear end to the port side "A"
in the figure. If the boat tends to veer to the
" (up) trims the
right (starboard side), turn the trim tab end to
the starboard side "B" in the figure.
ECM00840
The trim tab also serves as an anode to
protect the engine from electrochemical
corrosion. Never paint the trim tab as it
will become ineffective as an anode.
ZMU04601
For instructions on using the power trim
and tilt switches, see pages 53 and 55.
WARNING
CAUTION: