Operation
(on).
ECM00191
CAUTION:
Never turn the main switch to "
G
(start) while the engine is running.
Do not keep the starter motor turning
G
for more than 5 seconds. If the starter
motor is turned continuously for more
than 5 seconds, the battery will be
quickly discharged, thus making it im-
possible to start the engine. The starter
can also be damaged. If the engine will
not start after 5 seconds of cranking,
return the main switch to "
10 seconds, then crank the engine
again.
OFF
ON
START
EMU27670
Warming up engine
EMU27702
Electric start and prime start models
1.
After starting the engine, allow it to idle
50
" (on), wait
ON
START
ZMU01881
ZMU04590
for 3 minutes to warm up. Failure to do
so will shorten engine life.
2.
Check for a steady flow of water from the
"
cooling water pilot hole.
ECM00511
CAUTION:
A continuous flow of water from the cool-
ing water pilot hole shows that the water
pump is pumping water through the cool-
ing passages. If water is not flowing out
of the hole at all times while the engine is
running, overheating and serious dam-
age could occur. Stop the engine and
check whether the cooling water inlet on
the lower case or the cooling water pilot
hole is blocked. Consult your Yamaha
dealer if the problem cannot be located
and corrected.
EMU31730
EWM00180
WARNING
Before shifting, make sure there are no
swimmers or obstacles in the water near
you.
ECM01610
CAUTION:
Warm up the engine before shifting into
gear. Until the engine is warm, the idle
speed may be higher than normal. High
Shifting
ZMU01882