3Com TokenLink Velocity TokenLink VelocityTM XL PCI Network Interface Card User Manual page 46

3-16 C
HAPTER
Table 3-2 summarizes the Load parameters that can be
used with TLNKPODI.LAN. Detailed descriptions of the
parameters begin after the table.
Table 3-2 TLNKPODI.LAN Load Parameters
Parameter Units
SLOT= Decimal
FRAME= Text
NODE= Hex
NAME= Any
SLOT=<value> Required if there is more than one
3C359 NIC installed in the server; you will be prompted to
supply a value if you do not enter one. This parameter
specifies the slot number for the NIC. The slot number is
automatically assigned by the PCI BIOS.
There are two ways you can supply a slot number for the NIC:
Regardless of the method you choose, you must supply
a slot number for each 3C359 NIC installed in the server.
Once you have noted the slot number of each NIC, you can
include the Load and Bind commands in the server's
AUTOEXEC.NCF file so the driver will be automatically
loaded when you start the SERVER program.
After a server driver has been loaded, you can view the
configuration of each driver (including Load command
parameters) using the CONFIG command from the server
console command prompt.
3: N N W
OVELL ET ARE
Supported
Values
Value assigned
by PCI BIOS
TOKEN-RING
See detailed
description in
text.
N/A
Enter a value when prompted by the server.
Manually find the slot number by loading the driver
as described later in this chapter in "Finding the Slot
Number Manually."
E
NVIRONMENTS
Description
Sets the slot number prompts.
Specifies the frame types supported
on the network.
Default = TOKEN-RING
Overrides the default node ID.
Default = stored on board the NIC
Sets the optional logical board name
(17 characters maximum).
Default = absent