Advertisement
Owner's Guide
Transmitter Operation
Press Once to Lock Doors and arm the alarm (if equipped)
1
Press 2nd Time & Hold for Constant Lock Output
Press and hold for 3 seconds to activate Panic Mode
Press Once to disable Panic Mode
Press Once for Unlock doors and Disarm Alarm (if equipped)
2
Press & Hold for Trunk / Aux Output
2&3
Press both buttons for 3 seconds to activate Car Finder Mode
Press Once for Start - (2 Times if programmed for Safety Start)
3
Press & Hold for 3 seconds while running to turn off
2
3
1
While running with the key, press the button to activate Idle Mode
4
Hold for 3 seconds to enter User Programmable Features
4
Press and release button 4 then press and hold button 3 for three seconds
to activate the Timer Mode
Timer Mode
1.Press & release button #4, then press and hold button #3 for 5 seconds, the lights will turn "On".
2. While the parking lights are "on" the start cycle can be selected.
1 hour cycle
Press button #1
2 hour cycle
Press button #2
3 hour cycle
Press button #3
4 hour cycle
Press button #4
3. The system will start vehicle at selected start cycle for a period up to 24 hours.
DIAGNOSTICS
PARK LIGHTS
STATUS LED
3 Flashes
Series of 3 Flashes
3 Slow Flashes
No Flashes
4 Slow Flashes
Series of 4 Flashes
5 Flashes
Series of 5
Flashes
6 Flashes
Series of 6 Flashes
7 Flashes
Series of 7 Flashes
8 Flashes
Series of 8 Flashes
1 Park light flash
2 Park light flashes
3 Park light flashes
4 Park light flashes
DIAGNOSTIC CODE
Door Opened "M" Models
Start Attempt In Service Mode
Not in Reservation Mode "M" units
Hood Pin Grounded (Open)
Brake Pedal Shutdown
Tach Lock-Out
3 Start Attempts with no start
ATTENTION: THE SYSTEM MUST BE PLACED INTO SERVICE MODE BEFORE ANY UNDER HOOD SERVICING IS DONE TO
THE VEHICLE.
IT IS THE
RESPONSIBILITY OF THE VEHICLE'S OWNER TO INSURE THAT THIS IS DONE.
MANUFACTURER ACCEPTS NO RESPONSIBILITY FOR ACCIDENTAL STARTING WHILE VEHICLE IS BEING SERVICED.
System Service Mode - By Remote
ACTIVATE Service Mode (User Programmable Feature)
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button #3 and the ? symbol will come on solid.
4 - Press button #4 to exit User Program Mode.(System Is Now In Service Mode)
DEACTIVATE Service Mode
1 - Press and hold button #4 for 3 seconds. (The remote will beep twice)
2 - Press button #1 Five times or until the ? starts flashing on the LCD screen.
3 - Press button #2 and the ? symbol will turn off.
4 - Press button #4 to exit User Program Mode.(Serice Mode is Deactivated)
Emergency Service Mode - (Valet)
This feature will disable the system except for locking and unlock functions.
This mode can also used if a remote is lost, damaged or if the system malfunctions.
ENTERING SERVICE MODE
1. While the ignition is "On" press and hold the Program button on the antenna for 5 seconds or until the horn
(optional) honks 5 times.
Ignition
"On"
EXITING SERVICE MODE
1. While the ignition is "On" press and hold the Program button for 5 seconds or until the horn (optional) honks 2
times.
Note: Remote starter functions will be disabled and the LED will be "on" steady.
The door locks and the trunk release will still be operational.
7 sec.
Battery Replacement
The battery icon on the remote will indicate the present level of the transmitter battery. When the
transmitter indicates the battery is low it should be replaced. Replace with quality 1.5volt "AAA" battery.
Slide
Lift
+
-
Owner's Guide
1
THE
Advertisement
