Service Position; Maintenance - Ariens Compact 24 Manual

Ariens Dealers will provide any service or
adjustments which may be required to keep
your unit operating at peak efficiency. Should
engine service be required, contact an Ariens
dealer or an authorized engine
manufacturer's service center.
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.

SERVICE POSITION

(Figure 16)
WARNING: Before tipping unit up
onto housing, close fuel shut-off
valve, and drain fuel tank and fuel
sytem so no spills will occur (see
engine manual for complete
instructions). Ensure unit is secure
and will not tip over during

maintenance.

Place unit on a flat level surface. Tip unit
forward onto front of auger housing for
service. Ensure unit is secure and will not tip
over. Strap and clamp onto bench if needed.
Service Position
Figure 16
MAINTENANCE
MAINTENANCE SCHEDULE
The chart below shows the recommended
maintenance schedule that should be
performed on a regular basis. More frequent
service may be required.
MAINTENANCE SCHEDULE
Service
Performed
Check Dual
Handle
Interlock
Check
Fasteners
Check Clutch
Operation
Check Clutch
Spring
Adjustments
Clean Engine
Check Engine
Oil
Change
Engine Oil
Check Tire
Pressure
Check Auger
Gearcase
General
Lubrication
*
After first five hours of operation.
**
After first two hours of operation.
CHECK DUAL HANDLE
INTERLOCK
Without the engine running, press down
(engage) both clutch levers. Release
attachment clutch lever. Attachment clutch
should remain engaged until traction clutch
lever is released, then both clutches must
disengage.
CHECK FASTENERS
Make sure all hardware is tightened properly.
OS8190
GB - 20
Each Every Every
Use 5 hrs. 25
hrs.
•
•
•
* •
•
•
** •
•
•
•
Yearly
•
•