Table of Contents
Advertisement
Clear a Clogged Discharge Chute
WARNING: NEVER use your
hand to clean out discharge
chute.
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Use the snow clean-out tool to clear the
clog.
3. Return the tool to its storage position on
the auger housing.
STOP THE ENGINE
1. Release traction drive clutch lever.
2. Run auger / impeller for a few minutes to
remove loose or melting snow to prevent
impeller from freezing.
3. Release attachment clutch lever.
4. Move throttle control lever to the slow
position.
5. Turn engine key to stop position and
remove key.
6. Turn fuel valve to off position.
MOVE UNIT MANUALLY
See Figure 17.
• To disengage transmission and move unit
with the engine off, pull the bypass rod
outward.
• Push the rod in to engage the transmission
for normal operation.
Figure 17
TRANSPORT UNIT
1. Stop engine, remove key and close fuel
2. Secure unit chassis to transport vehicle.
NOTICE: NEVER secure from rods or
linkages that could be damaged.
Your Ariens dealer can provide service and
adjustments to keep your unit operating at
peak efficiency. Contact an authorized engine
manufacturer's service center for engine
service.
SERVICE POSITION
See Figure 18.
Normal
Operation
Move Unit
Manually
EN - 13
valve.
MAINTENANCE
WARNING: Read and
understand the Safety section
before proceeding.
WARNING: AVOID INJURY.
Properly remove fuel before
tipping unit up onto housing to
avoid spills. (Refer to engine
manual for instructions.) Make
sure unit is secure and will not tip.
Figure 18
Advertisement
Table of Contents
