Adjusting The Knee Pad Height - Invacare ROZE Owner's Manual

NOTE: The actuator lead wires will be visible after the large base cover is removed.
6. Remove the socket head screw and washer that attach the leg actuator to the base.
7. At the other end of the actuator, remove the socket head screw and nut that attach the leg actuator to the leg bracket.
8. If necessary, repeat STEPS 5‐7 on the opposite side of the base to remove the other leg actuator.
9. To replace the actuator(s), reverse STEPS 5‐7.
Caster
Leg
Large Base Cover

Adjusting the Knee Pad Height

NOTE: For this procedure, refer to FIGURE 7.3.
NOTE: When adjusted properly, the patient's knee will make
contact at the center of the knee pad.
1. While supporting the knee pad, disengage the quick
release knob on the side of the knee pad mounting
bracket.
2. Choose a height adjustment that will be comfortable for
the patient and will provide the necessary support.
Engage the quick release knob into position until the knee
pad is secure in place.
Part No. 1150703
BOTTOM VIEW OF
PATIENT LIFT
Pan head screw
(eight screws attach the
large base cover)
Mast Handles
FIGURE 7.2 Replacing the Leg Actuators
25
SECTION 7—MAINTENANCE
(eight screws attach each
small base cover)
Small Base Cover
Knee Pad
Quick Release
Knob
FIGURE 7.3 Adjusting the Knee Pad Height
Screw
Roze™ Stand Up Patient Lift