Maintenance; Washing Bed Ends - Invacare BAR600IVC User Manual

5 Maintenance

5.1

Washing Bed Ends

CAUTION
DO NOT wash head or foot section. AC motors and electronics are not water proof.
To protect flooring, ensure bed ends are completely drained and dry before placing on flooring. Otherwise, remaining dirty
water may damage or stain flooring.
Avoid spraying water directly into the gear box ends. Otherwise, damage to the gear box may occur.
1. Stand or prop each bed end in an upright position on its legs.
2. Using a mild soap/detergent and soft bristle brush or sponge, scrub all exterior surfaces.
3. Using a hose and nozzle attachment, rinse bed ends thoroughly with plain cold or warm water.
 Do not exceed a water temperature of 110° F.
Use household tap pressure. DO NOT use pressure
washers or steam cleaners.
4. Tip bed end from side to side to allow any collected or trapped
water to drain.
5. Thoroughly towel dry bed end and all components.
6. Repeat drying process until all components are dry.
 Ensure that the bed end is completely dry before
storing.
Part No 1123842
Gear Box
FIGURE 1 Washing Bed Ends
21
Invacare
5 MAINTENANCE
Bed End
® ™
IVC Model BAR600IVC Bariatric Bed