Kenwood TS-2000 Service Manual page 31

Item Condition
22. ALC meter 1) Menu No. : 87
start point (Frequency : 14.1MHz)
Transmit
Zone max. 2) Menu No. : 88
Transmit
23. FM DEV 1) Menu No. : 89
Wide (Frequency : 29.1MHz)
Transmit
Narrow 2) Menu No. : 90
Transmit
24. HF SWR 1) Menu No. : 118
protection (Frequency : 14.1MHz)
Transmit
150Ω dummy connection
: Use a cable that is 1m long
25. SWR meter 1) Menu No. : 119
(SWR : 3) (Frequency : 14.1MHz)
Transmit
150Ω dummy connection
: Use a cable that is approx.
10cm long
26. 50MHz 1) Menu No. : 120
SWR meter (Frequency : 50.1MHz)
(SWR : 3) Transmit
27. VHF SWR 1) Menu No. : 121
protection (Frequency : 145.9MHz)
ANT : Open
Transmit
28. UHF SWR 1) Menu No. : 122
protection (Frequency : 438.1MHz)
ANT : Open
Transmit
• Writing data : After items 5~8 and 12~28 have been adjusted;
1) Menu No. 124
2) [+] or [–] key : Push once time. Display "rEAdy" → "good" (If "nG" is displayed, enter data again.)
3) [CLR] key : Push once time.
29. AT detec- 1) Display f. : 51.990MHz
tion balance Mode : CW
Power : 10W
Transmit
1200MHz Unit Transmitter Section
Item Condition
1. TX IF gain 1) Display f. : 1270.000MHz
Mode : CW
Carrier : 0
Transmit
ADJUSTMENT (J TYPE)
Measurement
Test-
Unit Terminal
equipment
Power Rear ANT1
meter panel
Through ANT2
type power
meter
150Ω dummy
Ammeter ANT144
ANT430
Oscilloscope Filter TP1
(AMD)
Power Rear ANT1
meter panel
Measurement
Test-
Unit Terminal
equipment
Spectrum Rear ANT1.2G TX-RX3
analyzer panel
Power
meter
TS-2000/B2000/2000X
TS-2000S/2000V/2000SX/2000VX
Adjustment
Unit Parts Method
Front [+] key 1 push
panel
[+] key Set the adjustment
or value within the
[–] key limit of the specifi ed
power.
[+] key 1 push
[+] key Set the adjustment
or value within the limit
[–] key of the specifi ed cur-
rent.
Filter VR2 Turn the VR2 to the
point where the
waveform on the os-
cilloscope changes
from high to low.
(Threshold point)
Adjustment
Unit Parts Method
Set the carrier level
at approx. 100mW.
L2 Power max.
L3
L9
Specifi cations / Remarks
(ALC meter lights up to 1)
(ALC meter zone max.)
4.3kHz±0.05kHz
2.2kHz±0.05kHz
40W±1W : S,SX
8W±0.5W : V,VX
(SWR meter lights up to 3
level.)
11A±0.25A : S,SX
9.0A±0.25A : V,VX
9.25A±0.25A : S,SX
7.0A±0.25A : V,VX
Specifi cations / Remarks
31