GE JGBP24GE Use And Care Manual page 24

-.
Minor
Adjwtmenti
YouCanMake
Adjwtment -
Repeatedopeningsand closings
can cause the ovendoor to work
itself out of adjustment, One side
may close higher than the other,
and the door may not seal properly.
To adjust
the
height o f
the door:
1. Removethe door (see page 18).
,
I
... . . .-
2. With a thin-bladed screwdriver,
turn the screw in the opening at
the top of each door hinge. Turn
clockwiseto lower,counterclockwise
to raise each side of the door.
3. Replace the door, close it, and
check alignment and door seal.
BroiEand
oven
BurBler
Air
Adjustment
shutters
Air adjustmentshuttersfor the
broil and ovenburners regulatethe
flow of air to the flame.
The air adjustment shutter for the
top broil) burner is in the upper
righ~-handcorner near the rear wall
of the oven.
To adjust the flow of air to either
burner,loosen the Phillips head
screw and rotate the shutter to
allowmore or less air into the
burner tube as needed.
The flame for the top @roil)
burner should be steady with
approximately l-inch blue cones
and should not extend out over the
baffle edges.
The shutter for the bottom (oven)
To determine ;f the bottom (oven)
burner is near the back wall of the
burner flame is proper, remove
oven behind the storage drawer or
the oven bottom (see page 18)and
panel under the oven.
the burner baffle. The flame should
have 1/2"to 3/4" blue cones with no
yellow tipping. When the baffle is
back in place, the flame will resettle.
Visually check the color of the
flames every six months. If they
look like illustration (A) on page
25, call for service.
—
—