GE JGBP24GE Use And Care Manual page 18

oven
s helves
Oven shelvesmay be cleaned with
a mild abrasivecleanser following
manufacturer'sdirections. After
cleaning, rinse the shelveswith
clean water and dry with a clean
cloth. Toremoveheavy,burned-on
soil, soapy metalpads may be used
followingmanufacturer'sdirections.
Afier scrubbing, wash with soapy
water, rinse and dry,
oven Light Bulb
The light bulb is located in the
upper left corner of the oven. Before
replacing the bulb, disconnect
electric power to the range at the
main fuse or circuit breaker panel
or unplugthe range from the electric
outlet. Let the bulb cool completely
before removing it. Do not touch a
hot bulb with a damp cloth as the
bulb will break.
To remove: Hold hand under lamp
bulb cover so it doesn't fall when
released. With fingers of same
hand, firmly push down wire bail
until it clears cover. Lift off cover.
DO NOT REMOVE ANY SC~WS
~ REMOVE THIS COVER.
Replace bulb with a 40-watt home
appliance bulb.
To replace cover: Place cover into
groove of lamp receptacle. Lifi wire
bail up to center of cover until it
snaps into place. When in place,
wire holds cover firmly. Be certain
wire bail is not below depression in
center of cover.
Youcan remove the oven bottomto
clean anyexcessive spilloversbefore
startingihe self-clea; ing cycle.
To remove the oven bottom:
1. Removethe oven shelves.
/
Renlovabie
oven
D oor
The ovendoor is removableto make
the interior more accessibleduring
the replacementof the lamp bulb,
.—
'7
Open the ovendoor fully and
removethe two Philips screwsthat
hold the door to the hinges. Then
close the door to the automaticstop
position (at about 3 inches open),
and lift the door straightup and off
the hinges. (Due to the large amount
of insulation and the construction
2. Removethe two knurled hold-
of the door, it is heavy.)
down screws at the rear of the oven.
If they are too tight to remove by
hand, use a coin or a screwdriver.
3. To lift out the oven bottom,
placeyour
fingers in the slots in the
bottom and lifi the rear of the oven
bottom up and back until the oven
bottom is clear of the lip at the front.
4. Then lift the bottom up and out.
To replace the bottom, place it in
the oven with the back raised about
6 to 8 inches or until you can insert
the front of the oven bottom under
the hold-down lip at the front. Then
push the back of the oven bottom
down fully into place on the metal
flanges and insert the hold-down
screws.
Note: Care should be taken not to
place hands between the spring
hinge and the oven door frame as
the hinge could snap back and
pinch fingers.
To replace the door, make sure the
hinges are in the "out" position.
Position the slots in the bottom of
the door squarely over the hinges.
Then lower the door slowly and
evenly over both hinges at the same
time. If hinges snap back against
the oven frame, pull them back out.
'Whenthe door is in position, open
it fully and.insert the two Philips
screws.