Installing The Range - GE JBP79 Installation Instructions Manual

Installation Instructions
Installing the Range
Storage Drawer Removal
I-_ Pull the drawer
out until it stops
r-_ Lift the front of
the drawer until
the stops clear
the guide.
_ Remove the
drawer.
Stop
Final Check of the Anti-Tip Bracket
When installation is
complete and the
range is in place,
inspect to be sure the
rear leveling leg is fully
inserted into the slot of
the Anti-Tip Bracket.
Level the Range
The range must be level for proper cooking and
baking.
I-_ Install the oven racks.(See Owner's
Manual for instructions.)
I-_ Put a spirit level or a glass _R_T I--_====='_
SPIRIT
measuring cup partially
filled with water on one of
the oven racks.
Remove the
storage drawer.
The front leveling
legs can be
accessed from the
bottom and the
rear legs from the
top.
LOWER
LE_ES " _ _OE
I-_ Use an adjustable wrench to adjust all four
leg levelers until the range is level.
CAUTION: The oven door is heavy.
You may need help lifting the door
high enough to slide it into the
hinges slots. Do not lift the door by
the handle.
Replacing the Oven Door
r-_ Pick the Oven Door up
by placing both hands on
each side. The door is :
heavy so you may need
help. Do not lift the door
by the handle.
r_ Place the notch of the
hinge arm into the bot-
tom edge of the hinge
slot.
\ :ii_
r
Bottom Edge Hinge Arm
I-_-1-1 Open the oven door
as far as it will open.
Hinge Notch
Hinge in
Locked Position
Push the hinge locks
up against the front
frame of the oven
cavity, to the locked
position.
Close the oven door.
Hinge Securely
Fitted into Bottom
of Hinge Slot
9 Continued on following page