Storage Drawer Removal; Final Check Of The Anti-Tip Bracket; Level The Range; Replacing The Oven Door - GE 229C4053P447-3 1 Installation Instructions Manual

Installation Instructions

Installing the Range

D

Storage Drawer Removal

Pull the drawer
D1
out until it stops
Lift the front of
D2
the drawer until
the stops clear
the guide.
D3
Remove the
drawer.

Final Check of the Anti-Tip Bracket

When installation is
D4
complete and the
range is in place,
inspect to be sure the
rear leveling leg is fully
inserted into the slot of
the Anti-Tip Bracket.

Level the Range

The range must be level for proper cooking and
baking.
D5 Install the oven racks.(See Owner's
Manual for instructions.)
Put a spirit level or a glass
D6
measuring cup partially
filled with water on one of
the oven racks.
Remove the
D7
storage drawer.
The front leveling
legs can be
accessed from the
bottom and the
rear legs from the
top.
Use an adjustable wrench to adjust all four
D8
leg levelers until the range is level.
Stop
SPIRIT
LEVEL
LOWER
RANGE
LEG
LEVELER
RAISE
RANGE
CAUTION: The oven door is heavy.
You may need help lifting the door
high enough to slide it into the
hinges slots. Do not lift the door by
the handle.

Replacing the Oven Door

Pick the Oven Door up
D9
by placing both hands on
each side. The door is
heavy so you may need
help. Do not lift the door
by the handle.
Place the notch of the
D10
hinge arm into the bot-
tom edge of the hinge
slot.
Open the oven door
D11
as far as it will open.
Push the hinge locks
D12
up against the front
frame of the oven
cavity, to the locked
position.
Close the oven door.
D13
9
Hinge Arm
Bottom Edge
Of Slot
Hinge Notch
Hinge in
Locked Position
Notch of
Hinge Securely
Fitted into Bottom
of Hinge Slot
Continued on following page