Fagor 6FI-4GLS X Instructions For Use And Maintenance Manual

Fagor 6FI-4GLS X Instructions For Use And Maintenance Manual

Hide thumbs Also See for 6FI-4GLS X:

Advertisement

UK
INSTRUCTIONS FOR USE AND MAINTENANCE
FR
MANUEL D'INSTRUCTIONS
ÈÍCTPÓÊÖÈß ÏO OÁCËÓÆÈBAHÈÞ
RU
È ÝÊCÏËÓATAÖÈÈ
6FI-4GLS X
6FI-4GLST X
6FID-4GL X
6FID-4GL B
6FID-4GLS X
6FID-31ML X
6FID-31MLS X

Advertisement

Table of Contents
loading

Summary of Contents for Fagor 6FI-4GLS X

  • Page 1 INSTRUCTIONS FOR USE AND MAINTENANCE MANUEL D'INSTRUCTIONS ÈÍCTPÓÊÖÈß ÏO OÁCËÓÆÈBAHÈÞ È ÝÊCÏËÓATAÖÈÈ 6FI-4GLS X 6FI-4GLST X 6FID-4GL X 6FID-4GL B 6FID-4GLS X 6FID-31ML X 6FID-31MLS X...
  • Page 2 ATTENTION ! 1. Read this instruction manual thoroughly before installing or using the hob. 2. This hob must be installed according to the relevant regulations and used only in well ventilated rooms. 3. Before installing this appliance, check whether local gas supply terms (gas type and pressure) and settings match.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS OVERVIEW ........................ 3 HOB APPLICATION ............................3 TECHNICAL DATA............................3 HOB MODELS.............................3 SAFETY GUIDELINES..........................4 PREPARATION............................5 INSTALLATION ......................5 GENERAL NOTES ............................5 GAS HOB INSTALLATION .........................6 CONNECTING THE HOB TO THE NATURAL GAS SUPPLY ..............7 CONNECTING THE HOB TO THE LIQUID GAS BOTTLE ................7 NOZZLE REPLACEMENT ..........................8 ADJUSTING CONTROL KNOBS........................8 CONNECTING THE HOB TO THE MAINS ....................9...
  • Page 4: Overview

    OVERVIEW 1 OVERVIEW 1.1 HOB APPLICATION This gas-electric hob is intended for domestic cooking only. It must not be used for any other purpose. 1.2 TECHNICAL DATA Table 1 Total height Overall Width dimensions [mm] Depth Rated supply voltage 230V ~ 50Hz ...
  • Page 5: Safety Guidelines

    OVERVIEW 6FI-4GLSTX; Rapid burner R Triple-crown burner TC 3,0 kW 3,8 kW Auxiliary burner AUX Semi-rapid burner SR 1,0 kW 1,75 kW Control knob for TC burner Control knob for AUX burner Control knob for R burner Control knob for SR burner Fig.
  • Page 6: Preparation

    INSTALLATION In case of a gas leakage:  immediately close the valve of the gas system or gas bottle  ventilate the room thoroughly  call gas service During this time do not:  light matches or smoke  turn on or turn off electrical devices (radio, door bell, light) or mechanical devices that spark.
  • Page 7: Gas Hob Installation

    INSTALLATION  There must not be any cabinet fitted right above the hob.  In case of mounting a horizontal partition "A" under the hob, leave the distance at least 150mm between the hob and the partition (Fig. 6). Fig. 5 Fig.
  • Page 8: Connecting The Hob To The Natural Gas Supply

    INSTALLATION 6. After installing the hob, the horizontal partition "A" may be placed under the worktop which will protect the user against accidental touching of a hot hob from the bottom. Fig. 9 Fig. 10 2.3 CONNECTING THE HOB TO THE NATURAL GAS SUPPLY Attention ! 1.
  • Page 9: Nozzle Replacement

    INSTALLATION ATTENTION ! 1. Checking the leakage with an open flame (e.g. with a match or a candle) is unacceptable. It may lead to an explosion ! 2. Check condition of the hose and connection tightness regularly, according to the valid regulations.
  • Page 10: Connecting The Hob To The Mains

    OPERATION Then: – open the gas flow with a knob and light the adjusted burner, – set the knob in the simmering position . and then, without changing that position, remove it from the tap's mandrel  turn the adjusting screw "A" (Fig. 13) and observe the flame; set such a height of a flame so as it will not be extinguished by a small draught and while quickly turning the knob from full flame position to the economical flame position...
  • Page 11: Flame Adjusting

    OPERATION  For the proper operation ensure that burners and igniters are clean and dry.  If the hob is equipped with a flame failure protection after igniting the burner keep the control knob fully pushed for a while to activate the protection. ...
  • Page 12: Turning Off Burners

    OPERATION  if the flame goes out, repeat these steps keeping the knob pushed for 5 seconds longer  adjust to the desired flame height between 3.1.3 TURNING OFF BURNERS Turn the control knob clockwise to the zero position marked "". 3.1.4 OPERATING THE HOB SUPPLIED WITH LIQUID GAS FROM BOTTLE Before igniting the first burner, open the gas bottle valve and then ignite burners as described above.
  • Page 13: Operating The Hot Plate

    OPERATION 3.2 OPERATING THE HOT PLATE 3.2.1 OPERATING HINTS  Keep the plate clean. Dirty plate does not transfer all power.  Except first use, turn on the plate only after putting a pot on it.  Never put wet vessels on the plate as moisture causes corrosion. ...
  • Page 14: Vessel Selection

    OPERATION Cooking Roasting Turn the knob to position 6 and wait till the Turn the knob to position 6 and heat the oil. liquid starts boiling and turn to position 2 for Then put ingredients into vessel and turn the knob to position 4.
  • Page 15: Cleaning And Maintenance

    CLEANING AND MAINTENANCE 4 CLEANING AND MAINTENANCE Attention ! Before cleaning, you must disconnect the hob’s plug from the socket and turn off all burners. 4.1 GENERAL RECOMMENDATIONS Appliance must be regularly cleaned in order to maintain proper technical condition and good appearance.
  • Page 16: Abnormal Hob Operation

    ABNORMAL HOB OPERATION  Cleaned burner parts should be thoroughly dried because if they are wet the gas will not burn or will burn improperly. After drying, re-install the burner elements in the order reverse to that used during their removal and do not damage igniters and thermocouple ends.Cleaning the electric plate Clean the plate with a soft cloth or a sponge.
  • Page 17 ATTENTION ! 1. Lisez entièrement ce manuel d'instructions avant d'installer ou d'utiliser la table de cuisson. 2. Cette table de cuisson doit être installée conformément aux réglementations en vigueur et utilisée uniquement dans des pièces correctement ventilées. 3. Avant d'installer cet appareil, assurez-vous que les conditions locales en termes d'alimentation en gaz (type de gaz et pression) correspondent aux paramètres de la table de cuisson.
  • Page 18 INFORMATION FOR THE CORRECT DISPOSAL OF ELECTRICAL AND When the appliance reaches the end of its service life, you should not dispose of it with the general domestic waste. It can be taken free of charge to the local administrations' specific selective collection centres, or to distributors who provide this service.

This manual is also suitable for:

6fid-4gl b6fid-4gl x

Table of Contents