Messages And How To React To Them; Messages For Audio Functions - Pioneer AVIC-F320BT Operation Manual

Appendix

Messages and how to react to them

The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages for navigation functions
Message
Preparing to start up system...
please wait
Dataloading failed.
Application startup failed.
Check file on SD card. Press
"OK" to exit Application
Mode.

Messages for audio functions

When problems occur in the audio source, a message may appears on the display. Refer to the
table below to identify the problem, then take the suggested corrective action. If the error persists,
contact your dealer or your nearest Pioneer Service Centre.
Built-in CD drive
Message
Error-11, 12, 17, 30
Error10, 11, 12, 15, 17, 30, A0,
CHK CDCORE
Error-15
Error-23
When
When the navigation system starts,
the message is displayed if the re-
maining battery power of the de-
tachable device is low.
You may have transferred the data
from your mobile phone in a format
cannot be received by the naviga-
tion system.
The application is not stored on the
SD memory card.
The application failed to download
properly.
A file required for application start-
up is not stored on the SD memory
card or is damaged.
The SD memory card is damaged.
Cause
Dirty
Scratched disc
Electrical or mechanical
The inserted disc does not contain
any data.
The CD format cannot be played
back.
What to do (Reference)
! Wait until the message "Ready to start up
system." appears. After the message is dis-
played, the navigation system restarts.
! Consult the nearest authorised Pioneer ser-
vice station if this message persists.
! Select a suitable item and format, then
retry. (Page 71)
! Connect your mobile phone with another
method again and retry. (Page 58)
Use the utility programme navgate FEEDS to
confirm the proper solution.
Use the utility programme navgate FEEDS to
confirm the proper solution.
Use the utility programme navgate FEEDS to
confirm the proper solution.
Make sure there are no problems with the SD
memory card.
Action (Reference)
Clean the disc.
Replace the disc.
Turn the ignition switch OFF and back ON, or
switch to a different source, then back to the
CD player.
Replace the disc.
Replace the disc.
Appendix
127
Engb