Problems In The Audio Screen (During Ipod Playback); Messages And How To React To Them - Pioneer AVIC-X3 Operation Manual

MAN-AVIC-X3-EN.book Page 137 Wednesday, June 6, 2007 10:15 AM

Problems in the audio screen (during iPod playback)

Symptom
Cannot be operated.

Messages and how to react to them

The following messages may be displayed by your navigation system.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message
Please insert the appropriate disc.
This is not the appropriate disc.
Please insert the appropriate disc.
Irregular speed pulse signal is
detected. Please turn system power
off and check the installation. After
checking, please re-boot the system
and press "OK".
Speed pulse wire is not connected.
Please be sure to connect the system
to the speed pulse wire. Accuracy is
not fully ensured without speed
pulse.
Vibration is detected. Please turn
system power off and check the
installation. After checking, please
re-boot the system and press "OK".
Direction of G sensor is not correct.
Please turn system power off and
check the installation. After check-
ing, please re-boot the system and
press "OK".
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service centre.
This function is not available now.
Cause
The iPod is frozen.
The authorisation error has occurred. • Reconnect the iPod with the inter-
When
If you try to use a disc which is
incompatible with this system.
If you insert a disc upside down.
If the disc is dirty.
If the disc is cracked or otherwise
damaged.
If the Navigation system does not
receive the vehicle speed pulse.
The speed signal input (pink lead
wire) of the power cable is not con-
nected.
The navigation unit is installed in a
place where it may be affected by a
large vibration.
Direction of G sensor is set incor-
rectly.
Abnormal output is detected from
the Gyrosensor.
The screen cannot be displayed with
Vehicle Dynamics Display.
Because the sensor has not been
taught so the sensor information
cannot be acquired.
Action (See)
Reconnect the iPod with the inter-
®
face cable for iPod (sold sepa-
rately).
®
face cable for iPod (sold sepa-
rately).
• Set the ACC to Off and set it to On
again.
• Update the iPod version.
What to do
Insert a suitable disc.
Insert the disc with the label upward.
Clean the disc.
Insert a normal, round disc.
Consult your Pioneer dealer.
To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Re-install the navigation unit in a
place where the unit will not be
affected by vibration.
See the "Installation Manual" and set
the direction of the navigation unit
correctly.
Note down the error code shown on
the screen. Turn off the power, and
then contact your nearest Pioneer
service facility.
If the sensor learning status reaches
the Sensor Initialising status, the sys-
tem is ready to be used.
137