Motor Board (Pc1) Dip Switch Settings - Miller Electric SuitCase X-TREME 8VS WCC Owner's Manual

4-14. Motor Board (PC1) DIP Switch Settings

Notes
OM-237 323 Page 20
1
3
1 Motor Control Board PC1
2 DIP Switch
3 LED5
If protective coating is present, re-
move before setting DIP switch. It is
not necessary to reapply the protect-
ive coating.
2
Set switch position 1 so the depressed
section of the tab is toward 1 as
labeled on the switch. Set switch posi-
tion 2 so the depressed section of the
N E P O
tab is toward OPEN as labeled on the
switch. As shown in illustration.
Once the DIP switch is set LED 5 on
the motor control board will blink twice
as the feeder is powered up. This
2 1
blinking indicates everything is work-
ing properly and the DIP switch is set
correctly.
Ref. 247 678-A