NordicTrack Cx995 Elliptical User Manual page 8

7. Identify the Left Pedal (10), which is widest at the rear
and has an opening on the left side. Attach the Left
Pedal to the Left Pedal Leg (4) with two M8 x 54mm
Button Screws (83).
Attach the Right Pedal (11) to the Right Pedal Leg (5)
in the same way.
Attach two Pedal Wheels (28), an M10 Washer (126),
and the Left Upper Body Leg (31) to the Wheel Frame
(30) on the Left Pedal Leg (4) with an M10 x 78mm
Bolt Set (65). Make sure that the Bolt Set, Pedal
Wheels, Washer, and Upper Body Leg are oriented
as shown.
Attach the other two Pedal Wheels, the Right Upper
Body Leg, and an M10 Washer (not shown) to the
Wheel Frame (not shown) on the Right Pedal Leg (5)
in the same way.
8. Have another person hold the Console (17) near the
Upright (2).
Connect the Upper Wire Harness (115) to the wire har-
ness on the Console (17). Connect the Pulse
Extension Wire (114) to the pulse wire on the Console.
Next, locate the two ground wires that are attached
with a screw to the Upright (2). Connect the ground
wires to the two smallest wires on the Console.
Carefully insert all excess wiring up into the Console
(17) and down into the Upright (2). Attach the Console
to the Upright with four M4 x 16mm Screws (98).
(Note: The Screws may be shipped in the console
box.) Be careful to avoid pinching the wires.
9. Plug the Power Cord (116) into the Power Socket
(117) at the rear of the elliptical exerciser.
10.Make sure that all parts of the elliptical exerciser are properly tightened. Cover the floor beneath the
elliptical exerciser to protect the floor from damage. Note: Some extra hardware may be left over.
7
31
126
30
28
65
8
Do not pinch
the wires
during this step.
98
98
9
8
118
5
11
65
28
4
83
17
114
115
Ground
Wires
2
116
117
Wide
End
10