Setting Up The Laminator - Fellowes Titan A3 Instructions Manual

SETTING UP THE LAMINATOR

1.
Ensure the machine is on a stable surface. Check there
is enough clear space (min 50cm) behind the machine
to allow items to pass through freely.
2.
Select the correct power lead for the appropriate power
supply. Fit the lead to the machine (the socket is at the
rear of the machine).
STEPS TO LAMINATE
5.
Switch the power on (Power switch located at the rear
of the machine).
6.
Select the 'Standby' button on the control panel. Check
the LED controls turn on. The 75 micron and ready
LED's will flash for 5 seconds before automatically
selecting the 75 micron heat setting. Any setting can be
selected at any time as required. To open the machine,
it is normal for the machine to cool before opening.
The LED interface allows selection of these functions:
- 75,100,125,175,250 micron pouch settings
- Manual laminating
- Reverse
- 'Easi-access' to service the mechanism
7.
The laminator will automatically select the thinnest
pouch setting (75 micron) within 5 seconds of power-on
unless another setting is selected. During warm-up or
warm-down, the selected pouch setting will flash red.
8.
When the laminator has reached the chosen setting, the
LED will stop flashing and glow red. The machine will
sound 2 short alerts.
NEED HELP?
6
404415_2_EUR_Titan_All_v3.0.indd 6
3.
Plug the machine into an easily accessible mains socket.
Switch the mains supply on.
4.
To fully support pouches and items of different sizes
please use the adjustable entry guide to centre the item
before laminating. Place exit tray onto the rear of the
machine.
9.
Place item into open pouch. Ensure the item is centred
against the sealed front edge. Use the appropriate
pouch size for the item.
10.
Place the pouch, sealed edge first into the document
entry. Keep the pouch straight and central within the
document entry, not on an angle. Use the entry mark-
ings as a guide.
11.
Upon exit, the laminated pouch is hot and soft. Take
care and remove the pouch immediately. Place the
pouch onto a flat surface to cool. This helps prevent any
jamming.
12.
To reverse the laminating process at any stage, press
and hold the 'Reverse' button to eject the item. The
laminator will sound alerts continuously and the ready
LED will flash.
Let our experts help you with a solution.
www.fellowes.com
Customer Service:
Help Line Europe: 00-800-1810-1810
25/09/2009 09:21:14