Setting Water Hardness; Measuring Water Hardness; Set Water Hardness; Setting The Language - DeLonghi ESAM6620 Owner's Manual

Important! Danger of burns
Hot water containing acid flows out of the hot
water spout.
Avoid contact with splashes of water.
7. Confirm with the OK button.
8. The message "DESCALING IN PROGRESS"
is displayed. The descaling programme
starts and the descaler liquid comes out of
the water spout. The descale programme
automatically performs a series of rinses
and pauses to remove limescale deposits
from inside the machine.
After about 30 minutes, the message "RINSING...
FILL TANK!" is displayed.
9. The appliance is now ready for rinsing
through with clean water.
Remove the water tank, empty, rinse
under running water, fill with clean water
and replace. "RINSING... PRESS OK" is
displayed.
10. Empty the container used to collect the
descaler solution and replace it under the hot
water spout.
11. Press the OK button to start rinsing.
water flows out of the spout and the message
"RINSING..." is displayed.
12. When the water tank is completely empty,
the message "RINSING COMPLETE... PRESS
OK" is displayed.
13. Press the OK button, fill the water tank and
the appliance is ready for use.

SETTING WATER hARDNESS

The DESCALE message is displayed after a
period of time established according to water
hardness.
The machine is factory set for a hardness value
of 4. The machine can also be programmed
according to the hardness of the mains water in
the various regions, varying the frequency with
which the message is displayed.

Measuring water hardness

1. Remove the "TOTAL HARDNESS TEST"
indicator paper from its pack.
2. Immerse the paper completely in a glass of
water for one second.
3. After about a minute, 1, 2, 3, or 4 red squares
form, depending on the hardness of the water.
Each square corresponds to one level.
Level 1
Level 2
Level 3
Level 4

Set water hardness

1. Press the P button to enter the menu.
2. Press the
the
repeatedly until the menu arrow is on
"WATER HARDNESS".
3. Press the
SET symbol flashing on the display) until the
number displayed coincides with the number
of red squares on the test strip.
4. Press the OK button to confirm the setting.
5. Press the P button (corresponding to the
ESC symbol flashing on the display) to exit
Hot
programming mode or
parameters.
The machine is now reprogrammed with the new
water hardness setting.

SETTING ThE LANGUAGE

To change the language on the display, proceed
as follows:
• Press the OK button for at least 5 seconds
until the appliance displays the installation
message in various languages.
• When the language required appears, press
OK for 3 seconds.

TEChNICAL SPECIFICATION

Voltage:
Absorbed power:
Pressure:
Water tank capacity:
Size LxHxD:
Weight:
19
button (corresponding to
symbol flashing on the display)
button (corresponding to the
to change other
120 V~ 60 Hz max. 10A
1,8 litres
282x374x441 mm
1350W
15 bars
11,4 Kg