DeLonghi ESAM6620 Owner's Manual page 24

PROBLEM
The milk does not come out of the milk
spout. (B5).
The milk is not well frothed.
The milk contains bubbles or squirts out
of the milk spout.
The appliance does not come on.
"Energy Saving" mode is enabled, but
the cup warmer is hot
POSSIBLE CAUSE
• The intake tube is not inserted or is
inserted incorrectly.
• The froth regulator is incorrectly
adjusted.
• The milk container lid is dirty.
• The milk is not cold enough or is
not semi-skimmed.
• The froth regulator is incorrectly
adjusted.
• The milk container lid is dirty.
• It is not plugged into the mains
socket.
• The main switch is not turned on.
• A number of drinks have been
prepared in rapid succession.
22
REMEDY
• Insert the intake tube in the rubber
washer in the milk container lid
(fig. 16).
• Adjust following the instructions
in the section on preparing drinks
with milk.
• Clean the milk container lid as
described in the section "Cleaning
the milk container".
• You should ideally use skimmed or
semi-skimmed milk at refrigerator
temperature (about 5°C). If the
result is still disappointing, try
another brand of milk.
• Adjust following the instructions
in the section on preparing drinks
with milk.
• Clean the milk container lid as
described in the section "Cleaning
the milk container".
• Plug into the mains socket.
• Place the main switch on the back
of the appliance in the I position
(fig. 1).