Mac Filter Setup - TRENDnet 14dBi User Manual

5.2.2 MAC Filter Setup

Allows to create MAC filter rules to allow or deny unicast or multicast packets from limited number of MAC
addresses. Important to note that MAC filter rules have precedence over IP Filter rules.
Please click on Advance -> MAC Filter Setup and follow the below setting.
Access Control Type: By default, it's "Disable". Options are Disabled, Only Deny List MAC or Only Allow

List MAC. Click Save button to save your change.
Two ways to set the Access Control List:
Only Allow List MAC.

The wireless clients in the ACL List will be allowed to access to Access Point; All others will be denied.
Only Deny List MAC.

The wireless clients in the ACL List will be denied to access to Access Point; All others will be allowed.
MAC Address : Enter MAC address (e.g. aa:bb:cc:00:00:0a) and click "Add" button, then the MAC address

should display in the ACL List.
There are a maximum of 20 clients allowed in this ACL List. The MAC addresses of the wireless clients can be
added and removed to the list using the Add and Delete buttons.
Click Reboot button to activate your changes
TEW-455APBO High Power Wireless Outdoor PoE Access Point
70
User Manual