Weber Vieluxe Slide-In Dual Burner Station Installation Manual page 10

SLIDE-IN FLOOR PANEL
INSTALLATION
Once your burner station has been set into place and the
adjustable feet have be set to level your station to the
"island" structure countertop, install the floor panel.
Slide-In Burner Station
The floor panel will fit over the top of the adjustable feet.
VENTILATION
WARNING: Air holes must be provided in the
structure at the top and bottom to provide
ventilation in the event of a gas leak.
Air holes can be located in a low visibility area and should
be protected by screening material to prevent rodents and
insects from entering the structure. Air holes will also help
dry moisture.
Vieluxe ® cabinet vents (#61429) are available from your
dealer or call Vieluxe ® Customer Service at
1-866-VIELUXE.
© 2004 Weber-Stephen Product Co.. Vieluxe
200 East Daniels Road, Palatine, IL 60067-6266. U.S.A. 1-866-VIELUXE
■ Cross ventilation must be incorporated in the
supporting structure. We recommend a minimum of
100 square inches of venting per side.
■ Vents should be on two sides of the structure.
The above drawings are for reference only.
■ Location of the vents should be from the center,
outward.
■ Locate the vents at both the bottom of the structure
and at the top of the structure.
■ The bottom vents should be as close to ground level
as possible. Make sure the vent area is not blocked
by interior supports of the structure.
■ We recommend vents with screens.
■ Access doors to the structure are not considered vents.
■ Clean the vents periodically.
DANGER: Failure to follow recommended minimum
venting instructions can cause gas to collect in the
structure in the event of a gas leak. This may result
in a fire or an explosion which can cause serious
bodily injury or death, and damage to property.
® is a registered U.S. trademark of Weber-Stephen Products Co.,
10
OR
View of Left Side
OR
Front View
OR
Front View
View of Right Side
Back View
Back View