Invacare Arrow RWD Service Manual page 65

ELECTRONICS
Removing GB Controller (Wheelchairs
Equipped with Non-Powered Seating Systems)
(FIGURE 9)
1. Remove the battery boxes. Refer to REMOVING/
INSTALLING THE BATTERY BOXES in the Owner's
Manual, part number 1081227.
2. Remove the controller shroud (if applicable). Refer to
REMOVING/INSTALLING THE SHROUD in the
Owner's Manual, part number 1081227.
3. Remove the 5/16-18 x 1-inch hex head cap screw
that secures the controller bracket and jumper cable
to the base frame.
4. Remove the 5/16-18 x 1-inch hex head cap screw
that secures the controller bracket to the base frame.
5. Remove the 10-32 x 1/2-inch mounting screw and
ltwo (2) ockwashers that secures the front of the GB
controller and jumper cable to the controller bracket.
6. Remove the two (2) 10-32 x 1/2-inch mounting screws
that secure the rear of the GB controller to the con-
troller bracket.
10-32 x 1/2-inch
Mounting Screw
(WHEELCHAIRS EQUIPPED WITH NON-POWERED SEATING SYSTEMS)
Controller
Bracket
FIGURE 9 - REMOVING/INSTALLIN G THE GB CONTROLLER
Installing G/B Controller (Wheelchairs
Equipped with Non-Powered Seating Systems)
(FIGURE 9)
1. Secure the rear of the GB controller to the controller
bracket with two (2) of the NEW 10-32 x 1/2-inch
mounting screws. Securely tighten.
2. Secure the front of the GB controller and one end of
the jumper cable to the controller bracket with one (1)
of the NEW 10-32 x 1/2-inch mounting screw and
two (2) lockwashers. Securely tighten.
3. Secure one side of the controller bracket to the base
frame as shown in FIGURE 2 with one (1) of the
NEW 5/16-18 x 1-inch hex head cap screws. Se-
curely tighten.
4. Secure the other side of the controller bracket and
opposite end of jumper cable to the base frame as
shown in FIGURE 2 of the remaining NEW 5/16-18
x 1-inch hex head cap screws. Securely tighten.
5. Reinstall the controller shroud (if applicable). Refer to
REMOVING/INSTALLING THE SHROUD in the
Owner's Manual, part number 1081227.
6. Reinstall the battery boxes. Refer to REMOVING/
INSTALLING THE BATTERY BOXES in the Owner's
Manual, part number 1081227.
65
PROCEDURE 13
8-32 x 1/2-inch
Mounting Screws
Jumper
Cable
5/16-18 x 1-inch
Hex Head
Cap Screw
(
Lockwashers
5/16-18 x 1-inch
Hex Head
Cap Screw
GB Controller
E
L
E
C
T
R
O
N
I
C
S