Invacare Arrow RWD Service Manual page 42

PROCEDURE 9
22NF Batteries in Single Battery Box
(FIGURE 3)
NOTE: Note polarity of white battery cable (jumper)
battery terminal ends.
B
DISCONNECTING.
A
1. Remove battery terminal cap(s) from battery
terminal(s) ends. Refer to DETAIL "A" in FIG-
T
URE 3.
T
E
2. Disconnect WHITE battery cable (jumper) NEGA-
R TIVE terminal end from NEGATIVE (-) battery
N
terminal/post of front battery and disconnect
I
POSITIVE
E P
battery terminal/post of rear battery.
S
3. Disonnect NEGATIVE (-) BLACK battery cable
of the battery box top from NEGATIVE (-) bat-
tery terminal/post of rear battery.
4. Disonnect POSITIVE (+) RED battery cable on bat-
tery box top from POSITIVE (+) battery terminal/
post of front battery.
terminal end from POSITIVE (+)
CONNECTING.
1. Remove battery terminal cap(s) from battery
terminal(s) ends. Refer to DETAIL "A" in FIGURE
3.
2. Connect WHITE battery cable (jumper) NEGATIVE
terminal end to NEGATIVE (-) battery terminal/
N
post of front battery and connect POSITIVE
minal end to POSITIVE (+) battery terminal/post of
rear battery.
3. Place battery top upside down on top of rear bat-
tery.
4. Connect NEGATIVE (-) BLACK battery cable of
the battery box top to NEGATIVE (-) battery termi-
nal/post of rear battery.
5. Position battery box top right side up and rotate
outward toward right to expose POSITIVE (+) bat-
tery terminal/post of front battery.
6. Connect POSITIVE (+) RED battery cable on battery
box top to POSITIVE (+) battery terminal/post of front
battery.
7. Replace battery terminal cap(s) onto battery cable
terminal end(s).
8. Rotate top toward left into position. Secure in place.
9. Install the battery box into the wheelchair. Refer to
INSTALLING/REMOVING 22NF BATTERY BOX
in PROCEDURE 7 of this manual.
NOTE: New Battery(ies) MUST be fully charged BE-
FORE using, otherwise the life of the battery(ies) will
be reduced.
10. If necessary, charge the battery(ies). Refer to
CHARGING BATTERIES in PROCEDURE 7 of
this manual.
42
BATTERIES
ter-
P