Back Angle Adjustment - Invacare Arrow RWD Service Manual

PROCEDURE 8

BACK ANGLE ADJUSTMENT

(FIGURE 3)
1. Remove armrests from the wheelchair. Refer to IN-
B STALLING/REMOVING FLIP BACK ARMRESTS in
PROCEDURE 4 of the owner's manual, 1081227.
A
C
2. Remove the mounting screw and washer from the top
K
mounting hole of back angle plate and back cane.
NOTE: To avoid losing the insert in each back cane, thread
F
the mounting screw through the cane from the inside of
R
wheelchair to hold the insert in place.
A
M
E
TO ACHIEVE A BACK ANGLE OF:
ANGLE
80 O
O
85
90 O
95 O
O
100
BACK CANE MOUNTING HOLE
Top
Bottom
Top
2nd from Bottom
Top
Bottom
Top
2nd from Bottom
Top
Bottom
FIGURE 3 - BACK ANGLE ADJUSTMENT
3. Remove the mounting screw and washer from the
bottom mounting hole of the back angle plate and
back cane.
4. Reposition the back canes into the correct mount-
ing holes of the back angle plate to obtain a back
angle between 80
5. Torque mounting screws to 75-inch pounds.
6. Reinstall the armrests onto the wheelchair. Refer
to INSTALLING/REMOVING FLIP BACK ARM-
RESTS in PROCEDURE 4 of the owner's manual,
1081227.
BACK ANGLE PLATE HOLE
BOTTOM Center
38
BACK FRAME
o o o
and 100 in 5 increments.
TOP Front
BOTTOM Rear
TOP Front
TOP Front
BOTTOM Front
TOP Center
BOTTOM Front
TOP Rear
BOTTOM Front