Replacing The Camera - Lenovo IdeaCentre A730 Hardware Maintenance Manual

Step 9. Lift up the WLAN card to remove it from the socket.
Step 10. To install the new WLAN card:
a. Connect the data cable to the new WLAN card.
b. Line up the new WLAN card with the socket, snap it into position and secure it with the pins.
c. Connect the antenna cable to the new WLAN card.
Step 11. Reattach the rear cover to the LED panel.
Step 12. Reattach the hinge to the chassis, and reconnect the touch and LED panel cables to the
motherboard.
Step 13. Reattach the base cover and secure it with the screws.

Replacing the camera

Note: Turn off the computer and wait 3 to 5 minutes to let it cool down before removing the cover.
To replace the camera:
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4. Remove the base cover. Refer to "Removing the base cover".
Step 5. Remove the hinge from the chassis. Refer to "Removing the hinge from the chassis".
Step 6. Remove the rear cover. Refer to "Removing the rear cover".
Step 7. Remove the 2 screws that secure the camera to the front bezel. 1
.
Chapter 8 Replacing hardware
57