Jenn-Air 36" Installation Manual page 25

Install Drawer Panel
1. Align the slots in the door panel brackets, located on each
side of the drawer panel, with the holes that go through the
drawer trim and into the drawer.
2. Using Phillips head flat screws (provided with refrigerator),
attach the brackets to the drawer.
3. Move the drawer panel up and down or from side to side to
align. Do not fully tighten the screws.
A
B
A. Drawer overlay panel
B. Drawer panel bracket
Install Top Grille Panel
B
A. Top grille panel
B. Cabinet sides
Standard Installation - Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
2. Pull the grille panel down slightly to lock into place.
A B
A
B
Integrated Installation - Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into
place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door(s). Make sure
the refrigerator door(s) can open freely. If the door(s) opens too
wide, install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
3. Using a " hex key, tighten the door stop pin.
A. Door stop pin hole
Complete Installation
1. Use the installation block to measure the gaps between the
panels and adjacent cabinets.
Custom wood overlay panels may be made with a
(0.95 cm) or " (0.32 cm) gap between the panel and
cabinets and a " (0.32 cm) gap between the freezer and
refrigerator door(s) and the door(s) and top grille.
All purchased panel kits require a
between the panel and the cabinets and a
gap between the freezer and refrigerator door(s), and the
door(s) and top grille.
A
B
A. Adjacent cabinet
B. Installation block
C. Panel on door
A
"
" (0.95 cm) gap
" (0.32 cm)
C
25