HP Surestore Tape Library Model 2/15 User Manual page 61

3. Enter the three-part numerical password (see "Entering the
4. Press
5. SET IDs* displays. Press
6. Press
7. The current SCSI address setting flashes. Press
8. Press
9. WAIT FOR UPDATE displays briefly, then IDs SAVED displays.
10. Press
11. To save new settings can be saved to flash ROM, turn the library off, then
NOTE
After changing an address, it may be necessary to reboot the host for the new
SCSI IDs to be recognized.
Administration Menu Password" on page 4-7).
until SCSI IDs* displays, then press
NEXT
LIB BUS1 ID # or DRV# BUS# ID # displays. (LIB BUS1 ID # stands
for the current SCSI ID of the robotics controller.
DRV# BUS# ID # is the current SCSI ID setting for the drive number and
its associated bus #.)
until the setting to change displays, then press
NEXT
desired address displays, then press
until UPDATE IDs NOW displays, then press
NEXT
• If the new settings do not conflict with other SCSI IDs on the bus,
SCSI IDs* displays.
• If the new settings conflict with other IDs on the SCSI bus, CONFLICT
ABORTED displays briefly, then SET IDs* displays. Any changes
entered are lost, and previous steps must be repeated to set a new
address.
• If any buses are daisy chained together, make sure the SCSI IDs are
different for each device on the bus.
• If a serial communications error is detected while trying to set the
SCSI IDs, DRV CONNECT ERR displays, followed by IDs NOT
CHANGED. Any changes entered are lost. The SCSI IDs* menu
displays.
three times to return to the drive status ("ready" state).
CANCEL
turn it back on. This allows the settings to be recovered if the library is
powered off for more than ten days.
Specifying SCSI Addresses
ENTER
.
ENTER
NEXT
.
ENTER
Library Operation
.
.
ENTER
or until the
PREV
.
ENTER
4-11