Applying 9840 Cartridge Labels; Figure 4-4. Applying 9840 Cartridge Labels - HP Surestore Tape Library Model 10/588 Hardware Manual

Preparing Cartridges

Applying 9840 Cartridge Labels

Figure 4-4. Applying 9840 Cartridge labels

Cartridge labels reflect the cartridge media and usage. Cleaning cartridges have
DG CLN in the VOLSER and a "U" beneath the VOLSER. Diagnostic cartridges
have DG 000 in the VOLSER and an "R" beneath the VOLSER.
Refer to
cartridge.
1. Make sure that the cartridge has been at room temperature for at least 24
hours.
2. Clean the surface where the labels will be placed using a cleaning solution
made for this purpose. Refer to
additional information.
3. Locate the label that you require and refer to
Refer to
you want, peel the backing from the label and then slide it under the slots,
pressing it into place.
Notes:
1. Make sure that the labels are not placed elsewhere on the cartridge surface.
2. Make sure that the edges of the labels do not curl up; curling causes the
cartridge to stick in the drive loader.
4-4
Figure 4-4 and insert the label into the recessed area provided on each
Figure 4-4 and slide the label under the slots in the recessed area. If
"Cleaning the Cartridge Exterior"
Figure 4-4.
for