Cartridges; Preparing Cartridges; Handling A Cartridge; Inspecting A Cartridge - HP Surestore Tape Library Model 10/588 Hardware Manual

Cartridges

The chapter describes how to prepare and maintain cartridges.

Preparing Cartridges

The following pages describe how to prepare a cartridge for use in the LSM.

Handling a Cartridge

Generally observe the following protocols when handling cartridges:
• Keep cartridges clean.
• Inspect a cartridge before each use.
• Do not put a damaged cartridge into a drive or LSM.
• Do not open a cartridge.
• Do not release a leader block and pull tape from a cartridge.
• Do not handle tape that is outside the cartridge.
• Do not expose the tape or cartridge to direct sunlight or moisture.
• Do not expose a recorded cartridge to magnetic fields.

Inspecting a Cartridge

A defective or dirty cartridge can damage a drive. If you suspect a problem with
a cartridge, inspect it for these defects:
• Cracked or broken cartridge
• Broken leader block
• Broken leader block latch
• Damaged write protect switch
• Moisture
• Labels not firmly attached or extending over the cartridge edge
• Any other obvious damage
4
4-1