Applying Dlt Cartridge Labels; Figure 4-3. Applying Dlt Cartridge Labels - HP Surestore Tape Library Model 10/588 Hardware Manual

Applying DLT Cartridge Labels

The LSM uses DLTtape IV or IIIXT cartridges for data, plus diagnostic and
cleaning cartridges. Different types of data cartridges are distinguished by a
small "E" or "D" next to the last number in the VOLSER. Cleaning and
diagnostic cartridges are distinguished by "CLN" or "DG" in the prefix in the
VOLSER. The correct labeling follows:
• DLTtape IV data cartridges should be labeled with a "D" label.
• DLTtape IIIXT data cartridges should be labeled with an "E" label.
• Cleaning cartridges should be labeled with a "CLN" label.
• Diagnostic cartridges should be labeled with a "DG" label.
Note: Diagnostic cartridges are physically the same as data cartridges. The LSM
The operator is responsible for applying labels correctly as indicated above and
in Figure
applying labels. Labels can be inserted into the recessed area, or the backing
can be peeled away to expose the adhesive, if a more permanent application is
desired. Do not place labels anywhere but in the recessed VOLSER slot, and
make sure that the edges do not curl up, which might cause misreading or
sticking.

Figure 4-3. Applying DLT Cartridge Labels

software requires the "DG" label before it will use a cartridge for
diagnostic routines. One diagnostic cartridge is supplied with the LSM.
4-3. Cartridge surfaces should be clean and at room temperature when
Preparing Cartridges
4-3