A Known Issues; Pre-Os Linux Prompts Are Not Displayed; Potential Rhel Deployment Errors; Installing Rhel4U4 With Disks Without Partition Tables - HP BL860c Deployment Manual

A Known Issues

This section provides information on the known issues when using SSTK.
IMPORTANT:
may contain late-breaking known issues for this release that could not be included in this
document.

Pre-OS Linux Prompts Are Not Displayed

The pre-OS Linux prompts are visible through the MP LAN connections. This indicates that the
EFI Boot Manager console output device is not configured properly; the Linux console cannot
output to two console devices.
To configure the console output device correctly, at the EFI boot manager select Boot
Configuration Console Configuration Select Output Console, and then ensure that you
select only one device type that contains the string Acpi(HWP0002,700)/Pci(...)/Uart.
If you are using HP Integrity Virtual Machines (Integrity VM), you must specify the console
device as console=ttyS0 in the elilo.conf file.

Potential RHEL Deployment Errors

When using SSTK to deploy RHEL, the following two erroneous warning messages may occur
and should be ignored:
–
/mnt/sysimage/tmp/nfsmount umount failed (2)
This warning message can occur after the RHEL installation and before the system is rebooted.
–
Mounting other filesystems:
This warning message can occur after rebooting and during the RHEL startup; the system
continues the booting process to completion.

Installing RHEL4U4 with Disks Without Partition Tables

When installing RHEL4U4, the installer queries you whether or not there are hard disk drivers
without a partition table. SSTK automatically creates a partition table on the disk that is used to
install the operating system. However, if there are any other disks in the system that do not have
a partition table, the following option must be set in the sample-ks.cfg configuration file:
zerombr yes

IPMI Errors on RHEL4

After installing RHEL4, error messages appear when the system is loading the IPMI drivers
during the boot process and should be ignored.

Labeling Issue with RHEL4U5

Due to a partition labeling issue, it is not possible to have two versions of RHEL4U5 installed on
the same system.

SmartArray P600 in Slot 0 on sx2000 Server

The ACU does not display the I/O Cabinet, I/O Bay and I/O Chassis information when executed
on HP Integrity Superdome sx2000 server with a SmartArray P600 plugged in slot 0.
In the controller specification section, the ACU output file only shows slot 0 in the controller
field. This is due to an issue in one of the libraries that does not capture the the slot information
correctly.
To avoid this issue, do not use the SmartArray P600 in slot 0 on HP Integrity Superdome sx2000
server.
HP recommends that you review the readme file included with SSTK, which
mount: LABEL=/boot/efi1 duplicate - not mount [FAILED]
Pre-OS Linux Prompts Are Not Displayed 81